C2 Series 2
ENGLISH
1. Main Features
The PS series amplifiers are high quality and performance amplifiers. To get the maximum
result, it features a servo system, power supply and a fan with adjusted speed.
The main features include:
• XLR and 1/4’ jack balanced input
• Input sensitivity switch
• Output: Speacon and speaker terminals
• Stereo, bridge and parallel switch
• Soft start
• Perfect protection system for the speakers
• Thermal cut off (85°C protection)
• Current limiter
2. Precautions
• Use an adequate power source.
• Do not turn on several amplifiers at the same time.
• Do not allow that the ventilation holes in the front or in the back of the amplifier are
blocked in any way.
• Input level controls are present on each channel.
• Output can use speacon or binding posts.
• Please check carefully if the mode switch is in the correct position: stereo,
bridge or parallel.
• Clean the amplifier regularly. Especially the dustfilters located behind the front panel
should be cleaned regularly.
• Use a vacuumcleaner to remove dust inside the amplifier. Never use water.
• In case of a defect, contact your dealer.
To Next Page
Loading...
