Need help?Do you have a question about the JBL BP300.1 and is the answer not in the manual?
General| Number of Channels | 1 |
|---|---|
| THD at Rated Power | <1% |
| Amplifier Class | Class D |
| Power Output (RMS) | 300W |
| Frequency Response | 10 Hz - 320 Hz |
| Input Sensitivity | 200mV - 4V |
| Bass Boost | 0dB - 12dB @ 45Hz |
| Impedance | 2 Ohms |
Specifies the requirements for the audio signal generator used in testing.
Defines the resistive loads to be used for amplifier performance testing.
Explains the meaning of the power indicator LED's illumination and blinking.
Details RCA input jacks, speaker output terminals, and power connections.
Description of input level, crossover, and bass boost controls on the amplifier.
Identifies the type and quantity of fuses used in the amplifier.
Steps for marking and drilling holes for amplifier mounting.
Instruction on how to securely mount the amplifier to a surface.
List of components on the main printed circuit board, including FETs, transistors, and diodes.
List of integrated circuits used in the amplifier, such as op-amps and regulators.
Details of resistors and capacitors used, including type, value, and tolerance.
Includes components like potentiometers, switches, crystals, and mechanical parts.
Details the amplifier's built-in protection circuits for thermal, DC voltage, and short circuits.
Step-by-step guide to modify the amplifier to address the muting issue.
Schematic representation of the Pulse Width Modulation integrated circuit.
Diagrams for KIA393P and TL072CP comparator integrated circuits.
Schematic representations for NPN and PNP transistors used in the amplifier.
Diagrams for MOSFETs used in the amplifier, including IRF540, IRF9540, IRFZ44.
Diagrams for ESC25M-02D and other specialized transistors.
To Next Page
