three. Operation
The crossover frequency knob
determines the highest
frequency your subwoofer will
reproduce. It allows a seam-
less transition from the
subwoofer to the satellite
speakers. Experiment with
this adjustment to find the
crossover frequency that
sounds best with your speak-
ers. When using the speaker
level connections, the
crossover adjustment will also
limit the low frequencies
being sent to your satellite
speakers. This means that
your satellites won’t have
to try and reproduce the
information the subwoofer
is playing.
The phase switch is used to
adjust the relative polarity of
the subwoofer. Listen to your
Control subwoofer and main
speakers with the switch in
the “+” position, then listen
to the same material with the
switch set to “–”. Decide
which sounds better and
leave the switch in this posi-
tion. Repeat this procedure if
you change the location of
the subwoofer.
Volume
Power
The Control Series Subwoofers Incorporate an Auto Turn-On/Off Circuit.
Mode Procedure LED Status
Off Turn volume knob fully counterclockwise. Red
On If the subwoofer is already off, turn volume knob clockwise. Green
Auto Simply turn off receiver/amplifier. The subwoofer will turn off after Red
approximately five minutes. The subwoofer will turn on when your
receiver/amplifier begins playing again.
sub6
sub10
sub6
sub10
Crossover Frequency
Phase
Control Series sub6/sub10 OM 9/11/98 12:42 PM Page 6
To Next Page
Loading...
Need help?
General
