To Next Page

To Previous Page

Solution A: Rack Mounting Two Half Rack Mixer Ampliﬁers

To install two half-rack width units in your cabinet system, refer to Figure 2.2.3 and

follow the steps below:

1. Align two modules side by side and upside down with the front panel towards

the same direction.

2. Connect them with the ﬂat bracket using the screws provided.

3. Attach the front angle brackets to each side of the front of the ampliﬁer assem-

bly using the screws provided.

4. Attach the rear ﬂat brackets to each side of the rear of the ampliﬁer assembly

with the screws provided.

5. Install the assembly into the cabinet using the rack mount screws through the

front angle brackets. For details of installation in the chassis of the cabinet, refer

to the user guide of your cabinet.

6. Align the rear angle brackets with the proper holes at the rear of the cabinet and

attach using rack mount screws.

7. With the rear angle brackets to the outside of the ﬂat brackets, attach them each

using a screw passing through two washers, the rear ﬂat bracket and the rear

angle bracket as shown in the ﬁgure.

Figure 2.2.3 Rack mounting of two half rack Mixer units.

Other manuals for JBL CSMA 1120

Questions and Answers:

Need help?

Do you have a question about the JBL CSMA 1120 and is the answer not in the manual?

General