JBL EON 206P - Page 6

6
Section 3:
EON
206P
PA
System
Declaration
of
Conformity
This equipment complies with the EMC directive 89/336/EEC
Modified by
92/31/EEC
93/68/EEC
98/13/EEC and
LVD
73/23/EEC modified
by
93/68/EEC
This product meets safety standards:
EN60065:2002
UL6500
7th Edition:
2003
UL
60065-
STANDARD
FOR AUDIO, VIDEO AND
SIMILAR ELECTRONIC
APPARATUS- SAFETY
EQUIREMENTS-
Edition
7-
Revision Date
2007/12/11
CSA
C22.2
NO
60065-03-
AUDIO, VIDEO
AND
SIMILAR ELECTRONIC
APPARATUS-
SAFETY
REQUIREMENTS-
Edition
1-
Revision Date
2006/04/01
IEC
60065-
AUDIO, VIDEO AND SIMILAR ELECTRONIC
APPARATUS-- SAFETY
REQUIREMENTS-
Edition
7.1
-Issue
Date
2005/12/01
And EMC Standards
EN551
03-1
(E2)
EN55103-2 (E2)
FCC Compliance Notice
CE:
This device complies with part 15
of
the FCC
rules.
Operation is subject to the
following
two conditions: ( 1) This
device may not cause
harmful
interference, and (2) this device must accept any interference received,
including
interference that may cause undesired operation.
CAUTION:
Changes
or
modifications not expressly approved
by
the party responsible for compliance could
void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply
with the
limits for a Class
A digital device,
pursuant to part
of
the FCC Rules. These
limits are designed
to
provide reasonable protection against
harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and,
if
not
installed
and used in accordance with the instruction manual,
may cause harmful interference to radio
communications. However there is no guarantee that the interference will not occur in a particular installation.
If
this equipment does cause
harmful
interference to radio and television reception, which can be determined by
turning the equipment
off
and on, the user is encouraged to try
to
collect the interference by one
or
more
of
the
following
measures.
•
Reorient
or
relocate the receiving antenna
• Increase
the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult
the dealer
or
an experienced radio/TV technician
for
help