Need help?Do you have a question about the JBL SR Series and is the answer not in the manual?
General| Series | SR Series |
|---|---|
| Signal-to-Noise Ratio | >100dB |
| Input Impedance | 20kΩ balanced |
| THD | <0.05% @ full power |
| Protection | Thermal, short circuit, DC offset, overload |
| Power Output | Varies by model (e.g., SR4702: 700W per channel @ 4Ω) |
| Frequency Response | Varies by model (Typically 20 Hz - 20 kHz) |
Explains the manual's purpose and encourages user engagement.
Guides on checking the shipping carton and product for damage upon receipt.
Explains proper grounding for safety and noise reduction, including ground loop issues.
Details how to connect audio sources using balanced and unbalanced wiring.
Recommendations for cable types and balancing for optimal signal integrity over distance.
Discusses impedance matching for 600 ohm audio systems and its historical context.
Provides instructions on connecting speakers to the amplifier's output terminals.
Explains signal polarity at input and output connectors for correct operation.
Describes how to select operating modes like Stereo, Dual Mono, and Bridged Mono.
Outlines the correct sequence for powering on the amplifier safely.
Provides guidance on routine cleaning and general care of the amplifier.
Details the product's warranty terms and procedures for returning units for repair.
To Next Page
