- CONTENTS -
SPECIFICATIONS ………………………………………..1
PACKING……………………………………………..…....2
CONTROL/INSTALLATION DRAWINGS………………3
CONTROL/INSTALLATION INSTRUCTIONS………....4
BASIC TROUBLESHOOTING…………………..............5
EXPLODED VIEW…….………………….….…………....6
EXPLODED VIEW PARTS LIST………….…….….…....7
AMPLIFIER BLOCK DIAGRAM…………………….……8
ELECTRICAL PARTS LIST ..……….……….…….…….9
P.C.B. DRAWINGS….……………………….....….……15
IC/TRANSISTOR PINOUTS..………………..….….…..18
SCHEMATICS……………………………………….…...19
GTO 5355 Specifications
Output Power: 55W RMS x 4 channels + 225W RMS x 1 channel @ 4 ohms; ≤1% THD+N
(14.4V supply) 75W RMS x 4 channels + 360W RMS x 1 channel @ 2 ohms; ≤1% THD+N
140W RMS x 2 channel (bridged) @ 4 ohms; ≤1% THD + N
Signal-to-noise ratio: 85dBA (reference 1W into 4 ohms)
104dBA (reference rated power into 4 ohms)
Dynamic power: 660W @ 2 ohms
Frequency response: 10Hz – 83kHz and 20Hz – 250Hz (subwoofer)
THD+N 1KHz LPF=22KHz ≤0.03% (rated power @ 4 ohms)
Channel Separation ≥45db (full rated power)
Input Impedance >20K ohms
Maximum input signal: 6.0V
Maximum sensitivity: 100mV
Hi-Pass, Low Pass X-over Limits 32Hz – 320Hz + 20Hz – 200Hz ±20%
Bass Boost @ 50Hz 0-12dB
DC Offset <30mV
Output regulation: .03dB @ 4 ohms
Idle Current @ 4 ohms 1.9A
Max Current Draw <80A @ 2 ohms both channels driven
Remote Operating Voltages ON 5V OFF 4V
Turn-on delay time 2-3 sec
Circuit Protection Temperature (85±5C), Short circuit
Operating voltage range (8-16V)
Dimensions: 18 9/16 x 10 3/8 x 2 1/8” (470 x 263 x 53mm)
Fuses: (2) x 40A
JBL continually strives to update and improve existing products, as well as create new ones. The specifications
and details in this and related JBL publications are therefore subject to change without notice.
GTO5355
To Next Page
Loading...
Need help?
General
