MA7100HP | MA9100HP Owner's Manual | rev1.3 20240612
Pg 12 of 45
©2024 Harman International | Features, Specifications, and Appearance subject to change without notice.
BLUETOOTH OPERATION
Connecting your phone or tablet:
• Select the Bluetooth input on the AVR for Bluetooth pairing of a source device. Push and Hold the Input knob to
initiate Pairing Mode.
• To pair your Bluetooth source device, open the Bluetooth settings on your source device and scan for
MA7100HP/MA9100HP ###### from the list. Each product has a unique ID.
2. Push to Select “Bluetooth”
3. Push and Hold to activate Pairing Mode
4. Open the Bluetooth settings on your phone/tablet.
Scan for MA7100HP/MA9100HP ###### and select
from the list. Each product has a unique ID.
Push to Mute/Unmute
• The AVR can recall 7 device pairings. If 7 are in memory already, the oldest will be replaced.
• Because portable devices often have a volume slider. Upon pairing, there is a default volume setting in the amplifier to
prevent excessive volume output being selected accidentally. The default is 20.
Connecting your wireless headphones:
• To pair Bluetooth headphones, press on the remote control to access the TOP MENU and select Audio.
• Scroll down and select Bluetooth Setup.
• Once in the Bluetooth Setup menu, set Mode to “Transmit”.
• Next, scroll down and select “Transmit Pairing” and select “Search” to start searching for Bluetooth devices.
• Your headphone must be in pairing mode to be discovered and paired.
• When you see “searching…” pairable Bluetooth devices will be listed. Scroll down to pair new Bluetooth device.
• Bluetooth headphones cannot be used with the Bluetooth input.
To Next Page
Loading...
