Move the Master Power
switch (marked “Power” ¡)
to the “
•
” (On) position to use
the subwoofer. The SUB145
subwoofer will automatically
turn on or go into standby
(sleep) mode when left in the
auto mode (“Auto/On” switch
™ in the “Auto” position).
When your receiver or ampli-
fier is off, or is not sending
program material to the sub-
woofer, the subwoofer will be
in standby mode (LED will be
red). When the sub
woofer
senses an audio signal,
it will
automatically turn on (LED will
be green). If the subwoofer
does not sense a signal after
approximately twenty minutes,
it will automatically go back
into standby mode.
When the “Auto/On” switch
™ is switched to the “On”
position, the subwoofer will
remain on, whether or not
program material is playing.
If you will be away from home
for an extended period of time,
or if the subwoofer will not
be used, switch the Master
Power switch ¡ to the Off
position.
VOLUME
IMPORTANT: CONNECT STRIPED WIRE TO RED ( ) SPEAKER TERMINAL.
To Next Page
Loading...
Need help?
General
