Getting Started
JBL Synthesis
1-4
Do Not . . .
• Place the SDP-5 on a thick rug or carpet or cover the SDP-5
with a cloth, as this might prevent proper cooling.
• Place the SDP-5 on a windowsill or in another location in which
it will be exposed to direct sunlight.
• Obstruct the front panel IR receiver window shown on page
2-3. The remote control must be in line of sight with the IR
receiver for proper operation. Refer to page 2-9 for more
information about remote control operation considerations.
INSTALLATION CONSIDERATIONS
The SDP-5 requires special care during installation to ensure
optimal performance. Pay particular attention to the bulleted items
that begin below and to other precautions that appear throughout
this user guide.
Do . . .
• Install the SDP-5 on a solid, flat, level surface such as a table or
shelf or in a standard 19-inch equipment rack using the
enclosed rack-mount kit.
• Select a dry, well-ventilated location out of direct sunlight.
Do Not . . .
• Install the SDP-5 on a surface that is unstable or unable to
support all four of its feet, unless it is installed in an equipment
rack.
• Stack the SDP-5 directly above heat-producing equipment
such as power amplifiers or other components that generate
heat during use.
• Expose the SDP-5 to high temperatures, humidity, steam,
smoke, dampness, or excessive dust. Avoid installing the
SDP-5 near radiators and other heat-producing appliances.
• Install the SDP-5 near unshielded TV or FM antennas, cable TV
decoders, and other RF-emitting devices that might cause
interference.
Before moving the SDP-5, make sure it is powered off with the
rear panel power switch. Then, make sure the power cord is
unplugged from the wall outlet.
CAUTION
To Next Page
Loading...