JBL SDP-5 - Appendix; Specifications

Main Zone Audio Performance (continued)
Zone 2 Audio Performance
Main Zone Audio Performance
Audio Input & Output Connectors
Appendix
JBL Synthesis
A-2
SPECIFICATIONS
•8 stereo (RCA) or 5 stereo and one 5.1-channel or 2
stereo and two 5.1-channel connectors
•4 S/PDIF coaxial (RCA) and 4 S/PDIF optical (TosLink)
connectors
• Coaxial and optical input connectors conform to IEC-
958, S/PDIF standards
• Accepts 44.1, 48, 88.2, and 96kHz sample rates
• Accepts 16-24 bits PCM audio, Dolby Digital, dts, and
dts-ES discrete data formats
•8 unbalanced (RCA) connectors for Front L/R, Center,
Subwoofer, Side L/R, and Rear L/R
•1 unbalanced (RCA, variable output level) stereo
connector
•1 S/PDIF coaxial (RCA) connector
Analog Audio Inputs
Digital Audio Inputs
Zone 2 Audio Outputs
Main Zone Audio
Outputs
• 24-bit, 96kHz, dual-bit ∆∑ architecture
• 24-bit, 44.1 to 192kHz, multi-bit ∆∑ architecture
• 10Hz to 20kHz, +0.05dB/-0.1dB, -0.5dB at 40kHz,
reference 1kHz
• Below 0.008% at 1kHz, maximum output level
• 108dB minimum, 22kHz bandwidth
• 108dB minimum, 22kHz bandwidth
A/D Conversion
D/A Conversion
Frequency Response
THD + Noise
Dynamic Range
Signal-to-Noise Ratio
• 200mVrms (2Vrms for maximum output level) at 0dB
input gain
• 100kΩ in parallel with 150pF
• 150mVrms typical, 6Vrms maximum (RCA connectors)
• Maximum value with full-scale input signal and volume
at +6dB
• 100Ω in parallel with 150pF (RCA connectors)
•50Ω in parallel with 150pF (XLR connectors)
Input Sensitivity
Input Impedance
Output Level
Output Impedance
• 100Ω in parallel with 150pF (RCA connectors)
Output Impedance
• 24-bit, 44.1 to 192kHz, multi-bit ∆∑ architecture
• 10Hz to 20kHz, +0.1dB/-0.25dB, -0.75dB at 40kHz,
reference 1kHz
• Below 0.005% at 1kHz, maximum output level
• 103dB minimum, 22kHz bandwidth
• 103dB minimum, 22kHz bandwidth
• 200mVrms (4Vrms for maximum output level)
• 100kΩ in parallel with 150pF
• 200mVrms typical, 4Vrms maximum (RCA connectors)
•Maximum value with full-scale input signal and volume
at 0dB
D/A Conversion
Frequency Response
THD + Noise
Dynamic Range
Signal-to-Noise Ratio
Input Sensitivity
Input Impedance
Output Level