JBL SDP-5 - Page 67

CUSTOM SETUP
FRONT L/R 40Hz
CENTER 80Hz
SIDE L/R 80Hz
REAR L/R 80Hz
SUBWOOFER 80Hz
THX ULTRA2 SUB OFF
BGC N/A
ASA APART
SETUP
JBL Synthesis
3-28
FRONT L/R FULL, 30Hz to 120Hz, THX 80Hz
Opens the FRONT L/R SPEAKERS menu shown above, which can be
used to select a crossover point for the Main Zone audio output
connectors labeled Front L/R. When set to FULL, the SDP-5 sends a
full-range audio output signal to these connectors. Otherwise, the
SDP-5 activates a crossover point at the selected setting. Choose
the setting closest to the low-frequency rating of the associated
speakers.
FRONT L/R

CUSTOM SETUP

SPEAKERS

SETUP
Default Possible
Parameter Setting Settings
FRONT L/R 80Hz FULL, 30 to 120Hz, THX 80Hz
CENTER 80Hz FULL, 30 to 120Hz, THX 80Hz,
NONE
SIDE L/R 80Hz FULL, 30 to 120Hz, THX 80Hz,
NONE
REAR L/R 80Hz FULL, 30 to 120Hz, THX 80Hz,
NONE
SUBWOOFER 80Hz FULL, 30 to 120Hz, THX 80Hz,
NONE
THX ULTRA2 SUB OFF ON, OFF
BGC N/A ON, OFF
ASA APART TOGETHER, CLOSE, APART
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
SETUP

SETUP
INPUTS
SPEAKERS
REAR PANEL CONFIG
DISPLAYS
VOLUME CONTROLS
TRIGGER
LOCK OPTIONS
SPEAKERS
SPEAKER SETUP
CUSTOM SETUP
SYNTHESIS 7CH SETUP
SPEAKER DISTANCES
LEVELS CALIBRATION
80Hz 80Hz
80Hz 80Hz 80Hz
80Hz 80Hz
80Hz
L
M
SUB
R
C
SL
SR
RL
RR

CUSTOM SETUP
FRONT L/R 80Hz

FRONT L/R SPEAKERS
FULL
30Hz
40Hz
50Hz
60Hz
70Hz
80Hz
THX 80Hz
90Hz
100Hz
110Hz
120Hz
Custom Speaker Setups (continued from page 3-27)