SETUP
SDP-5
3-37
MEASURING SPEAKER DISTANCES
Selecting the SPEAKER SETUP menu SPEAKER DISTANCES option
opens the SPEAKER DISTANCES menu shown above, which can be
used to set the distance between the listening position and the
speakers connected to the Main Zone audio output connectors.
The SDP-5 features a speaker distance control that allows distances
to be entered for each speaker. This helps ensure accurate signal
arrival time at the listening position, but is not a substitute for
proper speaker placement.
To determine the appropriate setting for each speaker, measure the
distance between the listening position and the front baffle of the
speaker. Then, set the corresponding SPEAKER DISTANCES menu
parameter to the closest available setting.
SPEAKER DISTANCES
SETUP
Note:
When the system includes a calibrated JBL Digital
Equalizer, speaker distance parameters should
remain at their factory-default settings (0.0ft). The
digital equalizer will perform arrival time correction.
Default Possible
Parameter Setting Settings
FRONT LEFT 0.0ft 0 to 30ft or 0 to 12m
CENTER 0.0ft 0 to 30ft or 0 to 12m
FRONT RIGHT 0.0ft 0 to 30ft or 0 to 12m
SIDE RIGHT 0.0ft 0 to 30ft or 0 to 12m
REAR RIGHT 0.0ft 0 to 30ft or 0 to 12m
REAR LEFT 0.0ft 0 to 30ft or 0 to 12m
SIDE LEFT 0.0ft 0 to 30ft or 0 to 12m
SUBWOOFER 0.0ft 0 to 30ft or 0 to 12m
UNITS FEET FEET, METERS
. . . Measuring Speaker Distances continues on page 3-38
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP
SETUP
To Next Page
Loading...