To Next PageTo Next Page
Need help?Do you have a question about the JBL STAGE A100P and is the answer not in the manual?
General| Frequency Response | 35Hz - 150Hz |
|---|---|
| Amplifier Type | Class D |
| Crossover Frequency | 50Hz - 150Hz |
| Auto On/Off | Yes |
| Power Output | 150W RMS |
| Peak Power | 300 Watts |
| Driver Size | 10-inch |
| Inputs | LFE |
| Enclosure Type | Bass-Reflex |
| Phase Switch | 0 / 180 degrees |
Sets the subwoofer to automatically turn on when an audio signal is detected.
Indicates whether the subwoofer is in the On (blue) or Standby (red) state.
Determines if the subwoofer driver moves in or out of phase with main speakers.
Sets the highest frequency the subwoofer reproduces for smooth bass transition.
Adjusts the subwoofer's volume level relative to other speakers.
Connects the subwoofer to the dedicated LFE output of a receiver/processor.
Turns the subwoofer on or off, and conserves energy when not in use.
Connects the power cord to an active, unswitched electrical outlet.
Connects to a receiver's dedicated subwoofer/LFE output using an LFE cable.
Connects to a receiver's preamp outputs using an RCA Y-Adapter cable.
How to use the power switch and auto power mode for operation.
Sets the crossover frequency for smooth bass transition between speakers.
Sets the subwoofer's volume level for optimal balance with other speakers.
Optimizes bass impact by aligning subwoofer and speaker sound waves.
Instructions for installing spikes for carpeted surfaces.
