-
9
-
JBL SYNTHESIS SDP-25 General Setup / Input Setup
GENERAL SETUP
Before making initial setup adjustments you may wish to change some of the system settings
that will make it easier to configure your SDP-25. To do that, press the OSD button to call up the
Main Menu and then press the Down Navigation Button until General Setup is highlighted. Then,
press Enter to move to that menu.
General Setup
Language English
Front Brightness 75%
Volume Units dB
Volume Default On
Volume Level -30dB
Units of Measure Inch
RS232 Control Off
CEC Control Off
Menu Appearance
Transparency Mid
Status Message 3 Seconds
Menus 1 Minute
Global Lip Sync 0ms
Auto Power Down On
FW Version VX.xx/X.xx
Factory Settings
Complete information on the function and adjustments for the settings in this menu may be
found in the full Owner’s Manual, which may be downloaded from the Support section of the
JBL Synthesis web site a www.jblsynthesis.com. However, at this time there are three important
settings that you may wish to change.
• The Language setting may be changed to French, Spanish, Dutch, German, or Italian.
• You may display the Speaker Distances in centimeters, rather than inches, by changing the
Units of Measure setting.
• Changing the setting for “Menus” will keep the on-screen menus on the display for up to ten
minutes, making it easier to make initial setup adjustments.
• The adjustments made in the General Setup menu are applied to all inputs.
• The Factory Settings option is used to return all settings to their original factory defaults.
When these, or any other adjustments are complete press the Back button on the remote to
return to the Main Menu.
INPUT SETUP
If you have made any connections that are different from those shown in the factory menu
default settings chart on Page 7, press the down navigation button so that Input Setup is
highlighted and press Enter.
Input Setup
Source Blu-ray
Rename Blu-ray
Video Input HDMI 1
Audio Source HDMI 1
Secondary
Digital Audio Coax 1
Analog Audio Audio 1
Surround Mode PLII(x) Movie
Lip Sync 0ms
Audio Adjustment
Trigger B Off
Back
The settings in the Audio Adjustment sub-menu are best made when all other setup adjustments
are complete and a source is playing. See Page 12 for more information.
When configuring an Input note the following options:
• Connecting and configuring Secondary analog and/or digital inputs with a source allows
them to be used for the Zone 2 system since the output audio format must be the same as
the input. The SDP-25 does not convert one format to another.
• The Lip Sync setting made in the Input Setup menu is applied for that input source only and
is added to the Global Lip Sync entered in the General Setup Menu.
To turn or activate a voltage-controlled device such as a motorized screen or blinds when a
specific input is in use, change the setting for Trigger B to On.
To Next Page
Loading...
