Need help?Do you have a question about the JBL TL260 and is the answer not in the manual?
Power| maximum recommended amplifier power | 250 W |
|---|---|
| power handling (continuous/peak) | 125 W / 500 W |
| nominal impedance | 8 Ohms |
Audio| sensitivity | 92 dB |
|---|---|
| frequency response | 32 Hz – 40 kHz |
| crossover frequencies | 280 Hz, 1.2 kHz, 4.5 kHz, 20 kHz |
Transducers| ultrahigh-frequency transducer | 19 mm (3/4") Mylar Dome |
|---|---|
| high-frequency transducer | 25 mm (1") Pure-Titanium Dome in JBL EOS Waveguide |
| midrange transducer | 100 mm (4") PolyPlas Cone With Rubber Surround and Cast-Aluminum Chassis |
Dimensions and Weight| dimensions (H x W x D) | 1194 mm x 508 mm x 330 mm |
|---|---|
| weight per speaker | 38.2 kg |
Instructions for placing speakers on various floor types and using supplied spikes for carpeted surfaces.
Guide to connecting speaker wires correctly with polarity to ensure proper sound reproduction.
Illustrates how to connect the TL260 speakers to a single stereo amplifier for bi-wiring.
Provides a wiring diagram for connecting TL260 speakers using two separate amplifiers.
Steps to diagnose and resolve situations where no sound is produced by any speaker.
Guidance on troubleshooting a single speaker that is not producing sound.
Troubleshooting steps for when the system cuts out as the volume is increased.
Advice on fixing poor bass response, including checking speaker wire polarity.
To Next Page
