Button Description: ▲: forward ▼: reverse ◀: turn left ▶: turn right
S: Speed P:Emergency brake, press it and the running function will fail,
press again, it release.
The remote control is not a toy. It is for the adult use only, and should
not be used by a child. A close adult supervision is always required.
Reception range may change significantly with weather, battery, and
other environmental conditions.
Press the ▲ forward button, the car goes forward. Press ▼ reverse button,
the car goes reverse.
“P” stop button: Press this button, the vehicle will stop immediately and
indicator flash, vehicle has no move function either by controller or manual
control from the vehicle. Press the button again, indicator change to solid
light, vehicle back to operation mode. Press the turn left button car turn
left, Press the turn right button car turn right;(Note:The remote control
turning button needs pressing more than once while turning, otherwise it
will automatically return to the straight line. )
The S button is speed button, one light on is low speed, two lights on for
intermediate speed, three lights on for high speed.
Remote control operating instruction
Remote control is priority (when the car is in Remote control, the remote
control personnel can control the car forward and backward, high/Low
speed, steering and other functions, the driver CAN NOT operate the car).
3. Instruction of each switch and function button
22
Open the dust cover of the button.
21
1
Use a screwdriver to remove the battery cover of the remote control, insert
two AAA 1.5V dry batteries in correct polarity. Close the battery cover and
fix it with the screw. (Battery replacement also according to the above
steps)
2.Matching the frequency of car and remote control
1. Turn off the Power Switch on the car.
2. Remove the battery cover on the Remote Control and put in 2 AAA
battery, the three LED indicators will flash.
3. Turn on the Power Switch on the car, when the LED indicators stop
flashing and 2 of them are on, matching successes.
4. Once the matching is made, there is no need to match code again
only if the battery is replaced.
5. The Remote Control will enter a sleep mode if not used for a long time
and the LED indicators will be off. Press any buttons to wake up the
Remote Control, and it can be used normally.
1.All batteries should be inserted in the correct polarity.
2.Non-rechargeable battery cannot be recharged
3.Take out and properly deal with the dead battery. To avoid injury, please
keep kids away from the battery.
4.The direct contact between the positive and negative terminals may result
in fire or explosion. Avoid direct connect between the terminals.
5.Do not mix old and new batteries. Do not mix alkaline, standard(carbon-
zinc),or rechargeable(nickel-cadmium) batteries.
6.Only an adult who has read and understood the safety warnings can
replace the dry battery.
To Next Page
Loading...