Attachments
Auxiliary Circuits
97 9821/6100-4 97
Figure 83.
A Auxiliary locking peg
7. Insert the peg through the pedal by pressing the red button.
8. Make sure that peg sits properly in the hole and locked in position.
9. Hand held tool is live now and ready to use. Operate the hand held tool in accordance with the relevant
tool operator manual.
Disconnecting the Hand Held Tool
1. Make the machine safe.
Refer to: Maintenance Positions (Page 122).
2. Disable the hydraulic tool circuit.
3. Operate the hydraulic hand tool a few times to release any pressure trapped in the hoses.
4. Disconnect the hand tool quick release couplings.
To Next Page
Loading...
