jcb 9TFT User Manual

SERVICE MANUAL
DUMPER
10TFT, 9TFT, 9TST
EN - 9813/5350 - ISSUE 2 - 01/2018
This manual contains original instructions, verified by
the manufacturer (or their authorized representative).
Copyright 2018 © JCB SERVICE
All rights reserved. No part of this publication may
be reproduced, stored in a retrieval system, or
transmitted in any form or by any other means,
electronic, mechanical, photocopying or otherwise,
without prior permission from JCB SERVICE.
www.jcb.com
Foreword
The Operator's Manual
You and others can be killed or seriously injured
if you operate or maintain the machine without
first studying the Operator's Manual. You must
understand and follow the instructions in the
Operator's Manual. If you do not understand
anything, ask your employer or JCB dealer to
explain it.
Do not operate the machine without an Operator's
Manual, or if there is anything on the machine you
do not understand.
Treat the Operator's Manual as part of the machine.
Keep it clean and in good condition. Replace the
Operator's Manual immediately if it is lost, damaged
or becomes unreadable.
Contents
01 - Machine
06 - Body and Framework
09 - Operator Station
15 - Engine
18 - Fuel and Exhaust System
21 - Cooling System
24 - Brake System
25 - Steering System
27 - Driveline
30 - Hydraulic System
33 - Electrical System
72 - Fasteners and Fixings
75 - Consumable Products
78 - After Sales

jcb 9TFT Specifications

General

Brand	jcb
Model	9TFT
Category	Construction Equipment
Language	English

Summary

Foreword

01 - Machine

Acronyms Glossary

Glossary of acronyms used in the manual.

Safety

Comprehensive safety information, warnings, and risk assessment for machine operation.

About this Manual

Information regarding the manual's structure, general content, and model identification.

Description

Overview of machine components, their locations, and service points.

Cleaning

Procedures and guidelines for cleaning the machine, including preparation and methods.

06 - Body and Framework

06-00 General

General information and introduction to the body and framework section.

03 - Chassis

Details about the machine's chassis structure and components.

36 - Upper Crossmember

Procedures for removing and installing the upper crossmember.

06 - Moveable Panel and Cover

Information on access panels, engine compartment, and transmission covers.