1 - 1
Roadwheels
Removal
Procedure is the same for all four wheels.
Slacken off the roadwheel retaining bolts A, then raise and
support the ends of the machine on blocks as indicated.
Remove the roadwheels.
Replacement
Replacement is a reversal of the removal procedure.
Tighten roadwheel retaining bolts to the correct torque:
Wheels with 8 bolt fixing - 220 Nm, (162 lbf ft, 22 kgf m).
Wheels with 6 bolt fixing - 405 Nm, (298 lbf ft, 41 kgf m).
!!
WARNING
A raised and badly supported machine can fall on you.
Position the machine on a firm, level surface before
raising one end. Ensure the other end is securely
chocked. Do not rely solely on the machine hydraulics or
jacks to support the machine when working under it.
Disconnect the battery, to prevent the engine being
started while you are beneath the machine.
GEN-001
Section F
Transmission
9803/8500
Section F
1 - 1
Issue 3*
Tyres and Wheels
*
174360
AA
*
To Next Page
Loading...
