5 - 1
Greasing
The machine must be greased regularly to keep it working
efficiently. Regular greasing will also increase the machine's
working life.
Grease should be applied with a grease gun, normally two
strokes of the gun should be sufficient. Stop the greasing
procedure when fresh grease appears at the joint. Use the
recommended grease.
In the following illustrations, the grease points are numbered.
Count off the grease points as you apply grease to each one.
Refit the dust caps after greasing.
Quickhitch Pivot Pins - for interval see Service Schedule
Total of 9 grease points.
!!
WARNING
Safety Strut
If it is necessary to work with the loader arm raised, you
must fit the loader arm safety strut first. (See Loader Arm
Safety Strut).
2-1-1-6
Section 3
Routine Maintenance
9803/8500
Section 3
5 - 1
Issue 1
88
99
11
2233
4455
6677
174210
To Next Page
Loading...
