jcb ROBOT 150 - Page 51

10 - 6
Engine (cont'd)
Draining the Fuel Filter - Peugeot engine machines
- for interval see Service Schedule
The fuel filter is located on the rear left hand side of the
chassis. Illustrations X show early machines, illustration Y
shows later machines.
1 Stop the engine.
2 Open the engine compartment rear door.
3 Drain off any water in the bowl B by opening tap A.
4 Re-tighten tap A.
5 If there is sediment in the bowl B change the element F.
Changing the Fuel Filter Element - Peugeot engine machines
- for interval see Service Schedule
1 Stop the engine.
2 Open the engine compartment rear door.
3 Place a receptacle under the filter to catch any fuel.
Slacken tap A.
4 Support the bowl B and unscrew bolt C. Remove the bolt
C, remove and discard washer D and 'O' ring E.
5 Remove filter element F, bowl B and base G as a unit.
6 Discard 'O' ring H.
7 Separate element F, bowl B and base G.
8 Remove and discard seals J (3 off), discard 'O' ring L.
9 Lubricate all seals and 'O' rings with correct fuel oil.
10 Fit new seals J (3 off) to base G, bowl B and element F,
fit 'O' ring H to the centre of the element F.
11 Fit element F, bowl B, base G, to the head K.
12 Insert centre bolt C after fitting new washer D and 'O'
ring E. Tighten the bolt C carefully by hand to ensure
that all seals are correctly seated. Fit new 'O' ring L to
tap A and insert tap into base G.
13 Torque tighten bolt C to 8-11 Nm (6-8 lbf ft, 0.8-1.1 kgf m).
14 Slacken a fuel line connection at the fuel pump on the
engine or on the engine side of the priming pump M.
15 Prime the fuel pump M until fuel spurts from the
loosened connection with no entrapped air.
16 Tighten the fuel line connection and check filter for leaks.
Tighten connections or change seals as required.
Section 3
Routine Maintenance
9803/8500
Section 3
10 - 6
Issue 2*
*
CC
DD
EE
KK
HH
JJ
FF
JJ
BB
JJ
GG
LL
AA
MM
174380
193640
174520
X
X
Y