How to fix JCM GLOBAL RDM-100 Bank Note Validator sensor calibration error?
To address a sensor calibration error in your JCM GLOBAL Bank Note Validator, refer to the Calibration and Testing section in Section 6 of the RDM-100 Operation and Maintenance Manual.
Provides installation and operating instructions for the RDM-100 Banknote Validator unit.
Details the step-by-step procedure for installing the RDM-100 Unit.
Steps to retrieve a jammed banknote located inside the RDM-100 Unit.
Procedure to clear a banknote jam within the BNF Assembly.
Procedure to clear a banknote jam within the Transport Assembly.
Procedure to clear a banknote jam within the BAU.
Procedure to clear a banknote jam within the Holding Transport Rear Assembly.
Procedure to clear a banknote jam within the Upper and Lower Transport Assembly.
Procedure to clear a banknote jam within the RJ and Cash Box Transport Assemblies.
Guidance on cleaning sensors and rollers using appropriate materials.
Detailed steps for cleaning the RDM-100 Unit's sensors and rollers.
General instructions on cleaning sensors, rollers, and belts in the unit.
Procedure for cleaning sensors and rollers within the BNF Assembly.
Specific steps to clean BNF Remaining and Start Sensors and rollers.
Steps to clean BNF Stop Sensors 1 and 2, and associated rollers.
Procedure for cleaning sensors and rollers on the Transport Path.
General| Model | RDM-100 Series |
|---|---|
| Type | Bank Note Validator |
| Connectivity | USB, RS-232 |
| Acceptance Rate | >98% |
| Interface | USB, RS-232 |
| Communication Interface | USB, RS-232 |
To Next Page
