Unit 6, Logman Centre, Greenbank Crescent,
East Tullos, Aberdeen, AB12 3BG
Tel: +44 (0) 01224 870765 sales@jcmload.com www.jcmload.com
User Instructions
TURN ON LINK
On the load link there is a switch press to 1 position to switch the link on and
press 0 to switch the link off.
TURN ON SYSTEM
To turn on your ALRS system press the ON button, your handset will show the
ID number of the load cell and count down from 20 seconds and then display your
load (0.00Te)
To zero your load cell press the ZERO button and your handset will as (zero) and
then zero your system.
UNITS OF MEASUREMENT
To change your units of measurement press the PAGE button once and the
handset will show (UNITS) then press ON button to accept. Your handset will
display a unit, press the PAGE button to scroll through each of the units, once
you are happy with your selection press the button to accept.
PEAK MODE
To use the PEAK mode on the ALRS system press the PAGE button until PEAK is
displayed on the handset then press the ON button to accept. Your handset
will show (OFF, default setting), press the PAGE button and the handset will
show (ON), press ON to accept. Your handset is now set in peak mode and the
letter (P) will be displayed on the right hands of your display.
If you need to zero your peak load press the ZERO button to zero your peak
load.
To Next Page
Loading...
Need help?
General