JDS Uniphase Certifier40G - Replace Certifier40 G Battery

Using the Certifier40G
45
2.1.20 How do I replace an old battery?
The batteries are located on the bottom side of the units. To
remove the batteries:
1. Turn the unit off and disconnect the external power
supplies.
2. Unscrew the flip battery compartment door and open
it.
3. Pull the battery out and insert a new battery and close
the compartment door and fasten it in place with the
screw.
CAUTION
Only use standard JDSU Certifier40G
replacement batteries.