Testing Copper Cables
51
3.5 Set the Test Limit
In order to perform a certification, the appropriate test limit or
standard must be selected. See section 2.1.5 for setting up
your appropriate test limits.
3.6 Set the Cable Type
When performing a copper test, selecting the correct cable
type will set the right NVP for length measurements and
make sure the correct cable type appears in the report. See
section 2.1.6 for selecting the cable type.
3.7 Set Connector Information
Selecting the correct connector will ensure that the report will
include the correct connector.
Figure 38: Selecting the connector type
The top three items in the list are standard connector types.
The items below, list various connector manufacturers.
Select the desired connector manufacturer and then the
appropriate connector type.
To Next Page
Loading...