Page 5 of 24
2.1 HST-3000 RFC-2544 Test
Use this procedure to set up an HST-3000 to test a 10Mbps, 100Mbps, or 1000Mbps link.
Step Action Details
1. Install SIM Install Ethernet Module on the HST-3000.
2. Power On Press the green Power Key to turn on the HST-3000. Wait
approximately 1 minute for the Base Unit software to load.
3. Insert SFP For optical testing, insert desired SFP (1000BASE-SX, 1000BASE-LX)
into the optical SFP connector labeled R/T 1.
4. Clean & Inspect Before connecting to an optical link, make sure all fiber optic cables and
connectors are clean using a Fiber Inspection microscope.
5. Connect Connect the Ethernet test port to the Ethernet switch port under test.
• Use Orange Multimode jumper cables for 850 nm 1000BASE-SX.
• Use Yellow Single Mode Fiber jumper cables for 1310 nm
1000BASE-LX and 1550 nm1000BASE-ZX.
• Use CAT 5E or better cable for copper 10/100/1000BASE-T
connections
Technical Support tac@jdsu.com 855-275-5378
To Next Page
Loading...
