Page 19 of 24
2.4 T-BERD 6000A Loopback
Use this procedure to set up a T-BERD 6000A as a far-end (Z-side) loopback device.
Step Action Details
1. Install PIM Install the SFP or SFP+ Physical Interface Module (PIM) in the
T-BERD 6000A.
2. Insert SFP Insert desired SFP (1000BASE-T, 1000BASE-SX, 1000BASE-LX, or
1000BASE-ZX) in PIM.
3. Power On Press the ON/OFF button to turn on the T-BERD 6000A. Wait
approximately 1 minute for the Base Unit software to load.
4. Launch MSAM Press the SYSTEM button. The MSAM is represented by a BERT icon.
If the BERT icon is yellow, tap the icon to start the application. The
icon will turn yellow and the fan will start.
5. View Results Press the RESULTS button to watch the progress of the MSAM/BERT
Module startup.
6. Clean & Inspect While the BERT module is starting up, and before connecting to an
optical link, make sure the fiber and connector are clean using a Fiber
Inspection probe.
Technical Support tac@jdsu.com 855-275-5378
To Next Page
Loading...
