Page 20 of 24
7. Connect Connect the SFP on the T-BERD 6000A to the Ethernet switch port.
• Use Orange Multimode jumper cables for 850 nm 1000BASE-SX.
• Use Yellow Single Mode Fiber jumper cables for 1310 nm
1000BASE-LX and 1550 nm1000BASE-ZX.
• Use CAT 5E or better cable for copper 1000BASE-T connections
8. Select Test In the Test menu, select one of the following:
• For Layer 2 Electrical (Copper/RJ-45) Testing:
Ethernet>10/100/1000>Layer 2 Traffic> Terminate.
• For Layer 2 Optical Testing:
Ethernet>1GigE Optical>Layer 2 Traffic> Terminate.
• For Layer 3 IPv4 Electrical Testing:
Ethernet>10/100/1000>Layer 3 Traffic> IPv4>Terminate.
• For Layer 3 IPv4 Optical Testing:
Ethernet>1GigE Optical>Layer 3 Traffic> IPv4>Terminate.
9. Reset to Defaults In the Tools menu, select Reset Test to Defaults. Press OK to continue.
Technical Support tac@jdsu.com 855-275-5378
To Next Page
Loading...
