JDS Uniphase T-BERD 6000A - Page 24

Page 24 of 28
Technical Support tac@jdsu.com 1 866 228-3762
Systems Engineer Dave.Baker@jdsu.com 321-243-0600
7. Setup Select the Setup tab, select the indicated folders, and configure your test
as follows:
Folder
Option
Value(s)
Comment
Setup,
All Steps
Steps
RTT only
Bottleneck
Bandwidth (Mbps)
See Work Order for CIR
Connect to Server
See Work Order
For Layer 2 handoffs,
set to 192.168.1.3
Type of Service
See Work Order
For Layer 2 handoffs,
set to None
Connect to Port
5001
Source IP Type
Static
Source IP
See Work Order
For Layer 2 handoffs,
set to 192.168.1.2
Default Gateway
See Work Order
For Layer 2 handoffs,
set to 192,168.1.1
Subnet Mask
See Work Order
For Layer 2 handoffs,
set to 255.255.255.0
Encapsulation
See Work Order
None or VLAN.
Setup, RTT
Duration (seconds)
10
8. Run RTT Scan Ensure that the Z-side has been setup as a TCP Server, then tap
[Run TrueSpeed Test] at the bottom of the screen. The T-BERD will
measure the Baseline RTT.
9. Save Results At the conclusion of the test, tap [No]. Do not save the test report yet.