JDS Uniphase T-BERD 6000A - Page 6

Page 6 of 28
Technical Support tac@jdsu.com 1 866 228-3762
Systems Engineer Dave.Baker@jdsu.com 321-243-0600
 Use Yellow Single Mode Fiber jumper cables for 1310 nm
1000BASE-LX and 1550 nm1000BASE-ZX.
 Use CAT 5E or better cable for copper 1000BASE-TX connections
8. Select Test In the Test menu, select one of the following:
 For Layer 2 Electrical (Copper) Testing:
Ethernet>10/100/1000>Layer 2 Traffic> Terminate.
 For Layer 2 Optical Testing:
Ethernet>1GigE Optical>Layer 2 Traffic> Terminate.
 For Layer 3 IPv4 Electrical Testing:
Ethernet>10/100/1000>Layer 3 Traffic> IPv4>Terminate.
 For Layer 3 IPv4 Optical Testing:
Ethernet>1GigE Optical>Layer 3 Traffic> IPv4>Terminate.
9. Reset to Defaults In the Tools menu, select Reset Test to Defaults. Press OK to continue.
10. Setup Press the SETUP soft key on the top right side of screen. Select the
indicated folders and configure your test as follows. Leave all other
values at default, unless specified in the Work Order.
Folder
Option
Value(s)
Comment
Interface,
Connector
Electrical
Connector
SFP1 or SFP2
For Electrical tests, select
ETHERNET 1000BASE-T SFP
Interface,
Connector
Optical
Connector
SFP1 or SFP2
For Optical tests, select desired optical
SFP (1000BASE-SX, 1000BASE-LX,
etc.)
Interface,
Physical
Layer
Auto
Negotiation
See Work Order
Set to same value as Ethernet switch port.
Duplex
See Work Order
Options only displayed if Auto Negotiate
= Off
Speed
Ethernet
Encapsulation
See Work Order
None or VLAN
VLAN ID
See Work Order
Options displayed after tapping VLAN
field if Encapsulation = VLAN