JDS Uniphase T-BERD MTS 8000 - Using setups, actions, and results; Setup commands; Common Application Commands

Remote Operation Getting Started Guide
Using setups, actions, and results
14 Transport Module, DMC, MSAM, and 5800 Remote Operation
:SESSion:CREate This command creates a remote control session with the selected application.
:SESSion:STARt This command starts a previously created remote control session.
:SESSion:END This command terminates the current remote control session. The session will automati-
cally be ended when an application is shut down or the remote connection is terminated.
Common Application
Commands
The following commands apply to all test applications.
:INITiate
The :INITiate command starts the test if it is in the "stopped" state.
:ABORt
The :ABORt command stops the test if it is in the "running" state.
To perform a test restart and restart all test measurement results, perform a test stop,
followed by a test start.
Example:
> :ABORt
> :INITiate
> :SYSTem:ERRor?
0, "No error"
:EXIT
Shuts down the currently running application.
Using setups, actions, and results
Setup commands A unique SCPI command exists for every setup.
The setup value should be space-separated from the command, but there should be no
space before the port number and/or question mark.
NOTE
Commands do not return any values unless they are a query. Remember to
check each command with the :SYSTem:ERRor? query. If you do not
check each command, and one is incorrect, the error message does not
indicate the incorrect command.