6
PERFORMANCE
A clogged or dirty intake screen will greatly reduce performance.
If the pump is used on a dirty surface, raise it slightly to reduce the amount of
debris contacting the intake. If less flow is desired, adjust the regulator on the
sealing cover to restrict the flow.
Do not let the pump run when not submerged in water. That may damage the pump.
Always submerge the pump first, and then plug in the electrical outlet. At the
beginning, it probably can’t pump water, because there is air in the pum p and the
tube. Don’t worry about it. Please pull out and insert electrical outlet sever al times,
it will work normally.
MAINTENANCE
Unplug before cleaning.
To clean the pump, remove the back cover, sealing cover and the impeller.
Use a small brush or stream of water to remove any debris
CAUTION: The pump shaft can not be removed.
If the pump fails to operate, check the following:
Check the outlet and try another outlet to ensure the pump is getting electrical
power.
NOTE: Always disconnect from electrical outlet before handling the pump.
Check the pump outlet and tubing for kinks and obstructions. Algae may block
them, please flush out the algae with a garden hose.
Check the inlet to ensure it is not clogged with debris.
Remove the pump inlet to access the impeller area. Turn the rotor to ensure it
is not broken or jammed.
Monthly maintenance will prolong your pump’s life.
NOTE: Ensure that the electrical cord loops below the electrical outlet to form
a “Drip Loop”. This will prevent water from running down the cord into the
electrical outlet.
DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of
such waste separately for special treatment is necessary.
WEEE-Reg.-Nr. Lautet: DE 64890525
Manufacturer:
Zhongshan Jebao Electronical & Electrical Appliance Co., Ltd.
Tongmao Industrical Park,Dongsheng,
Zhongshan,Guangdong.China.
Email:info@jebao.com
Website:www.jebao.com
Tel:+86-760-22212306,22212307
Fax:+86-760-22212368
Importeur:
Silex GmbH ® - Weinstraße 22 – 63628 Bad Soden Salmünster
Tel. 06056/9120-0 – Fax 06056/9120-10 – info@silex.de – www.Silex.de
To Previous Page
Loading...
Need help?
General
