Jedia JMA-1410 - Front Panel Controls (Page 4); Chime; Input 1 Controls; Input 2,3 Controls

1.󰼿CHIME1. CHIME
2
Pressing chime switch, chime signal will be activated as a pre signal.
You can adjust level.
2. INPUT1 CONTROLS
3. INPUT 2,3 CONTROLS
Adjust level volume so as not to turn on +3CLIP LED under two~
three 0'clock of master volume this is control for mic input level.
Adjust level volume so as not to turn on +3 LED under two~three
0'clock of master volume this is control for MIC/LINE input closed.
OUTPUT SWITCH
This is for selector that send chime signal to master output.
Chime signal has a priority. When chime signal is activated,
signal output of input4~input10 will be closed.
스위치를󰼿누르면󰼿챠임󰼿신호가󰼿울리며,󰼿설치󰼿장소에󰼿맞게󰼿신호󰼿레벨을
조정할󰼿수󰼿있습니다.󰼿이󰼿신호는󰼿안내󰼿방송󰼿시작전의󰼿방송󰼿예고󰼿음으로
사용할󰼿수󰼿있습니다.
2.󰼿INPUT1󰼿CONTROLS
입력󰼿1의󰼿마이크󰼿신호레벨을󰼿조정할󰼿수󰼿있으며󰼿통상󰼿조정위치는󰼿마스
터󰼿볼륨이󰼿2󰾝3시󰼿방향으로󰼿조정된󰼿상태에서󰼿출력󰼿레벨󰼿메터의󰼿+3
LED가󰼿켜지지󰼿않도록󰼿레벨󰼿볼륨을󰼿조정󰼿하십시오.󰼿그리고󰼿신호입력
이되면󰼿시그널󰼿LED가󰼿켜집니다.
IMPORTANT NOTICE : Priority function will be given only for
selected output.
중요사항󰼿:󰼿OUTPUT󰼿SWITCH의󰼿선택된󰼿출력만󰼿우선권이󰼿부
여됩니다.
중요사항󰼿:󰼿모든󰼿스위치를󰼿󰼿󰼿󰼿󰼿󰼿,󰼿󰼿󰼿󰼿󰼿위치에󰼿선택시는󰼿컨덴사󰼿
마이크󰼿공급용󰼿전원이󰼿입력󰼿XLR잭에󰼿공급되도록󰼿설계되어󰼿
있습니다.󰼿언바란스󰼿다이나믹󰼿마이크를󰼿연결하면󰼿마이크󰼿유
니트가󰼿고장납니다.󰼿그리고󰼿레벨󰼿볼륨을󰼿최소로󰼿돌린󰼿상태에
서󰼿모드스위치를󰼿전환해야󰼿스위치󰼿이송시󰼿잡음󰼿출력이󰼿차단
됩니다.
OUTPUT󰼿SWITCH
챠임󰼿신호를󰼿마스터󰼿출력으로󰼿신호를󰼿보내기󰼿위한󰼿신호선택󰼿스위치
입니다.󰼿챠임󰼿신호에는󰼿우선권이󰼿있도록󰼿설계되어󰼿있으며󰼿챠임󰼿신
호가󰼿출력되면󰼿입력󰼿4󰾝10번󰼿신호󰼿출력은󰼿차단됩니다.
OUTPUT󰼿SWITCH
입력󰼿1의󰼿신호를󰼿마스터󰼿출력으로󰼿보내기󰼿위한󰼿신호선택󰼿스위치입
니다.󰼿입력1의󰼿신호가󰼿출력되면󰼿입력󰼿4󰾝10번󰼿신호출력은󰼿차단되도
록󰼿우선권󰼿기능이󰼿있습니다.
3.󰼿INPUT󰼿2,3󰼿CONTROLS
입력󰼿2,󰼿3의󰼿마이크/라인󰼿신호레벨을󰼿조정할󰼿수󰼿있으면󰼿통상󰼿조정󰼿위
치는󰼿마스터󰼿볼륨이2󰾝3시󰼿방향으로󰼿조정된󰼿상태에서󰼿출력󰼿레벨󰼿메터
의󰼿+3󰼿LED가켜지지󰼿않도록󰼿레벨󰼿볼륨을󰼿조정󰼿하십시오.󰼿그리고󰼿신호
입력이󰼿되면󰼿시그널󰼿LED가󰼿켜집니다.󰼿
OUTPUT󰼿SWITCH
입력󰼿1의󰼿신호를󰼿마스터󰼿출력으로󰼿보내기󰼿위한󰼿신호선택󰼿스위치입
니다.󰼿입력1의󰼿신호가󰼿출력되면󰼿입력󰼿4󰾝10번󰼿신호출력은󰼿차단되도
록󰼿우선권󰼿기능이󰼿있습니다.
PRIORITY
입력󰼿1의󰼿신호를󰼿마스터󰼿출력으로󰼿보내기󰼿위한󰼿신호선택󰼿스위치입
니다.󰼿입력1의󰼿신호가󰼿출력되면󰼿입력󰼿4󰾝10번󰼿신호출력은󰼿차단되도
록󰼿우선권󰼿기능이󰼿있습니다.
MODE󰼿SWITCH
OUTPUT SWITCH
This is selector that send signal of input 2,3 to the master output.
When input 2~3 are activated, signal of input 4~10 will be closed.
This is selector that send signal of input 1 to the master output.
When input 1 are activated, signal of input4~input10 will be closed.
IMPORTANT NOTICE : Serecting mode switch " "(HPF)," "
(flat) power will be supplied to input XLR connector for condensor
mic only. If you connect unbalanced dynamic microphone with them,
it may be defaulted and should be minimized level volume before
moving to mode switch for noise down.
OUTPUT SWITCH
PRIORITY 2~3
When you switch "on", priority is activated and will closed input
4~10.
MODE SWITCH
MIC : It is input mic switch of 300Hz H.P.F that makes sound
clearance. When you select switch, windy sound.
Resonance frequency, plosive sound will be removed.
MIC : This is MIC input switch without filter line.
LINE : Line input for CD CASSETTE, TUNER
MIC󰼿󰼿󰼿󰼿󰼿󰼿󰼿󰼿:󰼿300Hz󰼿H.P.F󰼿마이크󰼿입력󰼿선택󰼿위치이며󰼿실내공명󰼿주
파수,󰼿교통소음,󰼿바람소리,󰼿파열음등의󰼿소리를󰼿제거하여󰼿명료도를󰼿
향상시킵니다.
MIC󰼿󰼿󰼿󰼿󰼿󰼿󰼿󰼿:󰼿필터󰼿기능이󰼿없는󰼿마이크󰼿입력󰼿선택󰼿위치입니다.
LINE󰼿:󰼿라인󰼿입력󰼿선택󰼿위치이며󰼿CD,󰼿카세트,󰼿튜너󰼿등의󰼿라인레벨󰼿
출력󰼿제품으로부터󰼿신호공급이󰼿가능합니다.
4
LOW
HIGH
Pre Amplifier
-13 -8 -3 0
3
CHIME
56
7
89
10
3
2
1
JMA-1410
PRIORITY 3PRIORITY 2
LOW
HIGH
0
0
0
0
+
121+2
OUTPUT
SIG
0
10
0
10
0
10
LEVEL
121+2
OUTPUT
SIG
0
10
LEVEL
121+2
OUTPUT
SIG
0
10
LEVEL
121+2
OUTPUT
SIG
0
10
LEVEL
121+2
OUTPUT
SIG
0
10
LEVEL
121+2
OUTPUT
SIG
0
10
LEVEL
121+2
OUTPUT
SIG
0
10
LEVEL
121+2
OUTPUT
SIG
0
10
LEVEL
121+2
OUTPUT
SIG
MIC
LINE
0
10
MODE
LEVEL
121+2
OUTPUT
0
10
LEVEL
MIC
LINE
MODE
MIC
LINE
MODE
MIC
LINE
MODE
MIC
LINE
MODE
MIC
LINE
MODE
MIC
LINE
MODE
MIC
LINE
MODE
MIC
LINE
MODE
121+2
OUTPUT
SIG
0
10
LEVEL
POWER
1
MASTER
2
MASTER
21
1
2
3
4
5
6
F
RONT PANEL CONTROLS (전면기능)