Opening Sunroof
The sunroof has two programmed open posi-
tions, comfort stop position and full open
position. The comfort stop position has been
optimized to minimize wind buffeting when
driving with side windows closed and sunroof
open. If the sunshade is in the closed posi-
tion when initiating a sunroof open or vent
command the sunshade will automatically
open to the half open position prior to the
sunroof opening.
Express
Push the switch and release it within one-half
second, the sunroof will open to the comfort
stop position and automatically stop. Push
the switch and release it again, the sunroof
will open to the full open position and auto-
matically stop. This is called “Express
Open”. During Express Open operation, any
movement of the sunroof switch will stop the
sunroof.
Manual Mode
Push and hold the switch, the sunroof will
open to the comfort stop position and auto-
matically stop. Push the switch and hold it
again, the sunroof will open to the full open
position and automatically stop. Any release
of the switch will stop the sunroof movement.
The sunroof will remain in a partially opened
condition until the switch is pushed and held
again.
Opening Sunroof — Vent
Push and release the "Vent" button within
one-half second and the sunroof will move
from the closed position to the vent position.
This is called “Express Vent.” During Express
Vent operation, any movement of the switch
will stop the sunroof.
NOTE:
When the sunroof is in a full open or a partial
open position, Express Vent operation is not
available. You must push and hold the vent
switch to cycle the sunroof from a slide open
position to the vent position. Sunroof move-
ment will stop if the switch is released prior to
the sunroof reaching the vent position.
Closing Sunroof
Express
Pull the switch down and release it within
one-half second and the sunroof will close
automatically from any position. The sunroof
will close fully and stop automatically. This is
called “Express Close”. During Express Close
operation, any other actuation of the switch
will stop the sunroof.
Manual Mode
Pull and hold the switch down and the sunroof
will close from any position. Any release of the
switch will stop the movement and the sunroof
will remain in a partially closed condition until
the sunroof switch is pulled again.
Opening Power Shade
The sunshade has two programmed open po-
sitions: half open and full open positions.
When opening the sunshade from the closed
position, the sunshade will always stop at the
half open position regardless of express or
manual open operation. The switch must be
actuated again to continue on to full open
position.
51
To Next Page
Loading...
Need help?
General
