2. With the ignition switch in the ON position, and the
engine OFF or RUNNING, shift the transmission into
NEUTRAL (automatic transmission), or depress the
clutch pedal (manual transmission).
3. Move the 4WD Control Switch to the desired position.
4. After the desired position indicator light is on (not
flashing), shift the transmission into gear (automatic
transmission), or release the clutch pedal (manual trans-
mission).
NOTE:
•
Steps 1 and 2 in the “Preferred Procedure” and the
“Alternate Procedure” are requirements for shifting
the transfer case. If these requirements are not met
prior to attempting the shift or while the shift attempt
is in process, then the indicator light will flash, and the
current transfer case position will be maintained. To
retry a shift, move the 4WD Control Switch back to the
original position, make certain all shift requirements
have been met, wait five seconds, and try the shift
again.
•
The ignition switch must be in the ON position for a
shift to take place and for the position indicator lights
to be operable. If the ignition switch is not in the ON
position, then the shift will not take place and no
position indicator lights will be on or flashing.
MP3022 Selec-Trac IIT Transfer Case — If
Equipped
Operating Information and Precautions
The Selec-Trac IIt active on-demand transfer case pro-
vides four positions:
•
2–wheel (rear) drive (2WD) High range.
•
4-wheel drive auto (4WD Auto) High range.
•
Neutral.
310 STARTING AND OPERATING
To Next Page
Loading...
Need help?
General
