EasyManuals Logo

Jeep Liberty 2008 User Manual

Jeep Liberty 2008
487 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #343 background imageLoading...
Page #343 background image
turn on when the ignition switch is turned to the ON
position. They should both turn off with the engine
running. If the ESP/BAS Malfunction Indicator light
turns on continuously with the engine running, a mal-
function has been detected in either the ESP or the BAS
system, or both. If this light remains on after several
ignition cycles, and the vehicle has been driven several
miles/kilomters at speeds greater than 30 mph (48 km/
h), see your authorized dealer as soon as possible to have
the problem diagnosed and corrected.
NOTE:
9The ESP/TCS Indicator light and the ESP/BAS Mal-
function Indicator light will turn on momentarily each
time the ignition switch is turned ON.
Each time the ignition is turned ON, the ESP System
will be ON even if it was turned off previously.
The ESP Control System will make buzzing or clicking
sounds when it is active. This is normal; the sounds
will stop when ESP becomes inactive following the
maneuver that caused the ESP activation.
TIRE SAFETY INFORMATION
Tire Markings
NOTE:
P (Passenger)-Metric tire sizing is based on U.S. design
342 STARTING AND OPERATING

Table of Contents

Other manuals for Jeep Liberty 2008

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jeep Liberty 2008 and is the answer not in the manual?

Jeep Liberty 2008 Specifications

General IconGeneral
BrandJeep
ModelLiberty 2008
CategoryAutomobile
LanguageEnglish

Related product manuals