E-11
BLUETOOTH OPERATION
PAIRING A SMARTPHONE OR BLUETOOTH ENABLED DEVICE
The Bluetooth feature enables you to stream and play the digital music on your Bluetooth
enabled device to your unit.
1. Check your Bluetooth enabled device and make sure the Bluetooth feature is turned on.
Refer to manual of your smartphone or external Bluetooth enabled device if needed
2. Slide the FUNCTION SELECTOR (#29) to the /CD/AUX
position.
3. Press and hold the BLUETOOTH
BUTTON (#23)
to
enter Bluetooth mode.
4. “bt” will flash on the LED DISPLAY (#13) and the unit will go into Pairing mode.
5. Enable the Bluetooth function of the device you want to link to and enable the search or
scan function to find the CD-550BT.
6. Select "CD-550BT" from the list when it appears on your device screen. If required, enter
the pass code “0000” to pair (link) CD-550BT with your device.
7. If you are pairing (linking) your computer to the speaker using Bluetooth, you may need to
set the CD-550BT as your computer’s default sound device.
8. After successfully pairing the CD-550BT with your Bluetooth device, The “bt” will stop
flashing and remain lit.
9. If you want to pair (link) the CD-550BT with another Bluetooth device, press and hold the
BLUETOOTH PAIR BUTTON (#16)
a few
seconds. The
“bt” will flash. The CD-550BT will
go into Pairing/Discoverable mode. Repeat steps 4 & 5.
Now you can play music from your Bluetooth device wirelessly to the CD-550BT.
1. Select your favorite song, press the
Play/Pause
Button
on your Bluetooth device or the
CD
PLAY/PAUSE
BUTTON (#23)
on the CD-550BT to play or pause the song from
your Bluetooth device.
2. Press the CD SKIP+
BUTTON
(#15) or CD SKIP-
BUTTON
(#22) to select the
Next or Previous track.
(The SEARCH function does not apply to Bluetooth operation)
3. Slowly adjust both the volume controls of your CD-550BT and your Bluetooth device until
you reach a comfortable listening level.
Notes :
1. Refer to the manual of your cell phone, tablet PC, computer or other Bluetooth enabled
devices for Bluetooth operation since it may vary from model to model.
2. If your Bluetooth enabled device does not support A2DP profile, it will not play the music
through the speaker, even if paired (linked).
3. Remember to turn off the CD-550BT when you have finished listening, s
et the Function
Selector (#29) to the “OFF/TAPE” position
4. Don't forget to switch off the power of your Bluetooth device as well.
5. The music playback will automatically be paused when you have an incoming call. When
the call is ended, the CD-550BT will start playing again.
To Next Page
Loading...
