E-6
INSTALLATION OPTIONS
ATTACHING THE STAND (See Illustrations Below)
A. Turn the unit over as shown below, and align the mounting blocks on the top of the stand, with
the mounting openings located on the bottom of the main unit. Once in place, the 4 mounting tabs
on the stand will align with the 4 rectangular mounting slots located on the bottom of the unit. Make
sure the mounting tabs are lined up with the slots, and slide the stand towards the front of the unit
until the mounting stand it is fully inserted, and locked in place. Make sure the base is locked firmly
in place, so it does not come off.
B. To remove the stand, use both hands to hold the stand, and using two fingers, lift the two
locking tabs marked with arrows to unlock the base. Slide the stand towards the back of the unit to
unlock. When the stand is in unlock position, pull the stand upward to remove it.
FOR WALL MOUNTING (STAND MUST BE REMOVED)
It’s important to be sure there are no electric, gas or water lines located behind the wall where you
are attaching the unit. We recommend having this speaker professionally installed. Use the
included wall mounting accessories and template to attach the sound bar to the wall.
1.
Use the supplied wall mounting instruction sheet to make marks on the wall for the plastic
anchors. Make sure the marks are level before drilling.
2.
Drill 1/4” holes on the marks.
3.
Insert the included plastic anchors into the holes until they are flush with the wall.
4. Screwing the 2 included flat head screws into the plastic anchor holes and tighten the screws.
5. When the screws are tightened, the screw heads should be about ¼” away from the mounting
wall. Line up the keyhole slots located on the back of the main unit with screws in the wall.
To Next Page
