To Next PageTo Next PageWhat to do if my Jensen VM9214 unit will not power on?
The issue might be a blown fuse. Check the radio fuse and the car battery fuse; if either is blown, install a new fuse with the correct rating. If the problem is an illegal operation, press the RESET button located in the bottom right corner of the front panel.
Why is there no audio output from my Jensen Car Receiver?
Several factors could be at play. It might be due to an improper audio output connection, so check the wiring. The volume could be set too low, so increase the volume level. Review the wiring diagram to check the “MUTE” connection. The speakers could be damaged, so consider replacing them. A heavily biased volume balance can cause this, so adjust the channel balance to the center position. Finally, if speaker wiring is in contact with a metal part of the car, insulate all speaker wiring connections.
Why does my Jensen VM9214 have poor sound quality or distortion?
This could be happening for a few reasons. You might be using a pirated disc, so try using an original copy. The speaker power rating might not be compatible with the unit, so connect proper speakers. Also, the speaker could be shorted, so check the speaker contact.
What to do if the remote control does not function on my Jensen Car Receiver?
First, the battery might be depleted, so replace it with a new one. Also, the battery might be installed incorrectly, so remove it and install it correctly.
Why does my Jensen VM9214 unit reset itself when the engine is off?
This could be due to an incorrect connection between the ACC and positive battery wire. Check the wiring and correct it if necessary.
What to do if the image is blurred, distorted, or dark on my Jensen VM9214 Car Receiver?
This might be happening because the disc is illegally copied. Use an original disc instead.
Why is the image flashing or showing interference on the screen of my Jensen VM9214 Car Receiver?
This issue might arise if the DVD is not compatible with the current TV system settings, so change the setup to accommodate the disc. It could also be due to improper video signal connections, so check the wiring and correct it if necessary.
What to do if my Jensen Car Receiver disc does not play back?
There are several reasons why a disc might not play. The disc could be warped or scratched, so use a disc in good condition. It might be dirty or wet, so clean it with a soft cloth. The laser pickup could be dirty, so clean it with a cleaning disc. An incompatible disc might be used, so use a compatible disc. The disc rating might exceed the Parental Lock rating limit, so change Parental Lock settings to lower the restriction. The disc region code might not be compatible with the unit, so use a disc with the proper region code. Finally, the disc might be inserted upside down, so insert it with the label side up.
Why is the station searching weak on my Jensen VM9214?
This could be because the auto antenna is not fully extended or not properly connected. Connect the auto antenna control cable properly. Also, the LOCAL function might be activated, so turn the LOCAL function off.
What to do if the monitor does not open automatically on my Jensen VM9214 Car Receiver?
The TFT Auto Open feature might be turned off, so turn TFT Auto Open on.
General| Display Size | 6.2 inches |
|---|---|
| Resolution | 800 x 480 |
| Touchscreen | Yes |
| DVD Player | Yes |
| CD Player | Yes |
| Bluetooth | Yes |
| USB Port | Yes |
| SD Card Slot | Yes |
| Radio Tuner | AM/FM |
| Rear Camera Input | Yes |
| Built-in Microphone | Yes |
| Remote Control | Yes |
| Video Output | Yes |
| Navigation | No |
| Display Type | LCD |
| Compatible Formats | MP3, WMA, JPEG |
| Audio Output Power | 50W x 4 |
| Peak Output | 50W x 4 |
| Preamp Outputs | 3 |
