To Next PageTo Next PageWhat to do if my Jensen Car Video System will not power on?
If your Jensen Car Video System is not powering on, there are a few potential causes. The radio fuse or the car battery fuse might be open; in this case, install a new fuse with the correct rating. Alternatively, an illegal operation might have occurred, so press the RESET button located in the middle of the left side of the front panel.
Why is there no audio output from my Jensen VX7023?
If you are experiencing no or low audio output from your Jensen Car Video System, several factors could be responsible. It could be due to an improper audio output connection, so check the wiring. The volume might be set too low, so increase the volume level. Review the wiring diagram and check the “MUTE” connection, as it might be improperly connected. Damaged speakers could also be the reason, requiring replacement. A heavily biased volume balance might cause this, so adjust the channel balance to the center position. Finally, if speaker wiring is in contact with a metal part of the car, insulate all speaker wiring connections.
What to do if my Jensen Car Video System resets itself when the engine is off?
If your Jensen Car Video System resets itself when the engine is off, it might be due to an incorrect connection between the ACC and the positive battery wire. Check the wiring and correct it.
Why does my Jensen VX7023 Car Video System have poor sound quality?
Poor sound quality or distortion in your Jensen Car Video System can stem from a few reasons. Using a pirated disc can cause this, so use an original copy. Also, the speaker power rating might not be compatible with the unit, so connect proper speakers. Finally, a shorted speaker can lead to poor sound quality, so check the speaker contact.
General| Brand | Jensen |
|---|---|
| Model | VX7023 |
| Category | Car Video System |
| Language | English |
