- - 2 - -
Jet Inc. 750 Alpha Drive Cleveland, OH 44143 www.jetincorp.com 800.321.6960
Safety Instructions
WARNING: Hazardous voltage can shock, burn or cause death.
TO AVOID SERIOUS OR FATAL PERSONAL INJURY OR MAJOR PROPERTY DAMAGE,
READ AND FOLLOW ALL SAFETY INSTRUCTIONS IN THE MANUAL FOR THE CONTROL
PANEL.
This is a SAFETY ALERT SYMBOL. When you see this symbol on the pump or in the
manual, look for one of the following signal words and be alert to the potential for personal
injury or property damage.
• Warns of hazards that WILL cause serious personal injury, death or major property damage.
• Warns of hazards that CAN cause serious personal injury, death or major property damage.
• Warns of hazards that CAN cause personal injury or property damage.
BOLD FACE FONT INDICATES SPECIAL INSTRUCTIONS WHICH ARE VERY IMPORTANT
AND MUST BE FOLLOWED.
THIS MANUAL IS INTENDED TO ASSIST IN THE INSTALLATION AND
OPERATION OF THIS UNIT. THOROUGHLY REVIEW ALL INSTRUCTIONS
AND WARNINGS PRIOR TO PERFORMING ANY WORK ON THIS CONTROL
PANEL.
MAINTAIN ALL SAFETY DECALS.
Install, ground and wire according to local and National Electrical Code Requirements.
Disconnect and lockout electrical power before installing or servicing the control panel.
Electrical supply must match nameplate specifications inside of the control panel. Incorrect
voltage can cause fire, damage control panel and void the warranty.
All single phase pump motors and aerators attached to model 197 Control Panels must be
equipped with an automatic thermal protector, which opens the motor’s electrical circuit
when an overload condition exists. This can cause the pump to start unexpectedly.
Important Precaution:
All electrical work must be preformed by a qualified technician. Always follow the National Electric Code
(NEC), or the Canadian Electrical Code, as well as local, state and provincial codes. Code questions should
be directed to your local electrical inspector. Failure to follow electrical codes and OSHA safety standards
may result in personal injury or equipment damage. Failure to follow manufacturer’s installation
instructions may result in electrical shock, fire hazard, personal injury or death, damaged equipment,
provide unsatisfactory performance, and may void manufacturer’s warranty.
To Next Page
Loading...
Need help?
General