11
Filter Bag Installation – DC-1200A/RC
Referring to Figure 7:
1. Place the hanger (A) on the hanger bracket (B).
2. Slide the filter bag loop (C) over the hanger hook.
3. Thread the retainer strap (D) through the loops on
the filter bag (E) and fasten to the collector
housing (F).
Collector Bag Installation – DC-1200A/RC
Referring to Figure 8:
4. Insert the ring (A) of the collector bag into the
bottom of the housing (B) at an angle. Pull down
on the bag to make sure it “seats” in the housing.
5. Position the plastic window in front so that you can
easily see when the collector bag is full.
After completing the filter bag and collector bag
installation, proceed to Electrical Connections.
Figure 7
Figure 8
To Next Page
Loading...
