13
STEP 6:
Hook the top loop of the upper bag over the
support bracket. Place the upper bag and
bottom bag over the top edge of the collector
and pull the strap tight to secure. Slip the bag
clamp around the filter bag and tighten down.
(See FIG. 6)
(FIG. 6)
STEP 7:
Press the four to one inlet onto the inlet cover
flange. The inlet is secured to the collector
body by a press on fit. (See FIG. 7)
(FIG. 7)
STEP 8:
Now your dust collector is finished assembly and ready
to be used. Before connecting to a power source, please
be sure the power source is properly grounded and is the
correct voltage and amperage. (See FIG. 8)
(FIG. 8)
To Next Page
Loading...
