Operational Hints
Caution
Wearing a particle mask/respirator for
protection against fine dust particles during
cleaning is highly recommended.
Clean the collector bag frequently to keep the
collector's performance at its optimum. Always
wear a particle mask while cleaning the bag.
To clean:
1. Disconnect the machine from the power
source.
2. Loosen the bag clamp, remove the bag
from the outlet, and empty the contents.
3. Turn the bag inside out and shake
vigorously.
4. Turn the bag outside in and re-attach to the
outlet using the bag clamp to secure.
5. Connect the machine to the power source.
Note: Use the proper type hose to connect the
dust collector to the machine being operated.
Dryer vent hose is not acceptable for this
purpose. Contact your nearest JET distributor for
the full line of JET Dust Collector Hoses and
Accessories.
To Next Page
Loading...
Need help?
General
