4
Warning
1. Read and understand all safety warnings.
2. Replace the warning labels if they become obscured or removed.
3. This press is designed and intended for use by properly trained and experienced personnel only. If
you are not familiar with the proper and safe operation of an hydraulic press, do not use until proper
training and knowledge has been obtained
4. Do not operate this press beyond its rated capacity.
5. This press is designed for pressing, bending, and straightening purposes only.
6. Do not operate this tool while tired or under the influence of drugs, alcohol or any medication.
7. Check the press for loose or damaged parts before each operation. Replace damaged parts and
tighten all loose bolts before operating.
8. Some parts being pressed may have a tendency to pop out of the press or explode under pressure.
Protect yourself accordingly.
9. Always wear approved safety glasses/face shields and personal safety equipment. (Everyday
eyeglasses only have impact resistant lenses; they are not safety glasses.)
10. Failure to comply with these warnings may result in serious injury.
To Next Page
Loading...
Need help?
General
