5
4.0 Specifications for JET Router Lift and components
Table 1
Component stock numbers
Router Lift with Cast Table Kit (includes items marked *)
737000CK
Router Lift with MDF Table Kit (includes items marked °)
737000WK
JRL-912 Router Lift *°
737000
Fence Assembly 32 in. *°
737001
Cast Iron Table 32x24 in. *
737002
MDF Table 32x24 in. °
737003
Floor Stand (with Power Switch and Miter Gauge) *°
737004
Dust Collection Box *°
737005
Power Switch
737006
Phenolic Inserts – set of 5 (ZC, 6.4, 12.7, 30, 63.5 mm)
737007
Flip Stop *°
737008
Fine Fence Adjuster (set of 2) *°
737009
Vertical Feather Board (set of 2) *°
737010
Horizontal Feather Board (set of 2)
737011
Power switch and electrical
Switch type Magnetic, paddle style with safety key
Input power and built-in receptacle 120-volt, single phase
On/off switch Magnetic, paddle style with safety key
Power cord 3Cx2.08mm
2
14AWG 300V, 6ft 9in.
Power plug included 120V
Capacities
Miter gauge angle 30 deg. L and R
Router vertical movement 0.08 in. per turn of handle (0.002 in. graduation marks)
Dimensions of accepted routers (round body only) Minimum 3-1/4ӯ with collar, Maximum 4-1/4ӯ
Dimensions
Router Lift plate 9.25 x 11.75 in. (235 x 299 mm)
Insert provided 1-1/2 in. I.D.
Table 24 x 32 in. (610 x 813 mm)
Fence dust port 2-1/2 in. (63.5 mm) O.D.
Fence body length 32 in. (813 mm)
Sub-Fence length Two at 16 in. (406 mm)
Dust collection box dust port 4 in. (101.6 mm) O.D.
Complete kit, fully assembled LxWxH 40 x 32 x 42 in. (1016 x 813 x 1067 mm)
Number of table T-slots 2
Table T-slot size WxD 3/4 x 3/8 in. and 3/8 x 1/4 in.
Main materials
Table Cast iron or MDF (melamine surfaced)
Fence body and rails Extruded aluminum
Sub-fences MDF (melamine surfaced)
Stand Steel
Weights (approximate)
737000CK
Net weight, fully assembled 229 lb. (103.92 kg)
Shipping weight, complete crate 315 lb. (142.75 kg)
737000WK
Net weight, fully assembled 173 lb. (78.5 kg)
Shipping weight, complete crate 255.6 lb. (116 kg)
1
Subject to local/national electrical codes. Recommendation based upon dedicated circuit.
2
The specified values are emission levels and are not necessarily to be seen as safe operating levels. As workplace
conditions vary, this information is intended to allow the user to make a better estimation of the hazards and risks
involved only.
L = length, W = width, H = height, D = depth O.D. = outside diameter
To Next Page
Loading...
