Jet JRL-912 - Dust Collection Box Install; Mounting Table to Stand

9
5.5 Dust Collection Box
See Figure 5-7.
1. Assemble panels as shown, using M4x6 pan head screws (#3). Do not fully tighten screws yet. When all
screws are inserted, place box on level surface and push down to settle it evenly. Then tighten all screws.
2. Install dust port (#19) and hose with clamp (#13/20).
Cast iron table is heavy! Use an assistant to help lift and assemble to stand.
3. Turn cast iron (or MDF) table upside down. Use mat or cardboard underneath to prevent scratching table
surface.
4. Install dust collection box to bottom of table. Cast iron table: Use six hex cap screws, lock washers, and flat
washers into threaded holes. MDF table: Use Phillips pan head wood screws into pilot holes.
5.6 Mounting table to stand
1. Mount table to stand and secure with fasteners. Cast iron table: Use socket head cap screws, lock washers
and flat washers (#15/16/17, Figure 5-7) into threaded holes. MDF table: Use Phillips pan head wood
screws into pilot holes.
Figure 5-7
2N
7
13
4
19
20
3
3
15
16
17
1N
6N
9N
3
to Table
Vent
Cable clamp