Jet JRL-912 - Stand Assembly

8
Applicability of the following instructions will depend upon your choice of accessories. Call-out numbers are
those in the parts breakdown, sect. 11.0.
5.4 Stand assembly
See Figure 5-6.
1. Mount support bars (2 long, 2 short) to legs (#4). Mount lower braces (2 long, 2 short) to legs. Position JET
logo toward front of stand.
2. Install levelers (#19). These can be adjusted for height at any time to make the stand level and
accommodate use of the wheels and swivel caster. Tighten leveler hex nut against stand.
3. Install wheels (#12) with brackets, and swivel caster (#14) with its bracket.
4. Mount power switch with bracket (#10) and storage hook assembly (#42) to legs.
Figure 5-6
2
2
3
3
4
4
7
5
6
8
14
19
20
20
21
21
22
21
25
27
30
20
21
26
21
20
22
21
21
41
41
41
6
12
10
42