Jet SPACE BALLZ - Section Assembly

To Next Page

To Previous Page

INSTALLATION INSTRUCTIONS

Step # 2

Check Box When This Step is Complete

Step # 2-B

Removing section # 3 from the crate properly

Lift Section # 3 out of the wooden crate by lifting on the metal

support bars as seen in the photo to the right. PLEASE SEE STEP # 2-C

BEFORE PROCEDING.

WARNING

2 PEOPLE REQUIRED - 150 POUNDS

Step # 2-A

Opening the upper section crates

Remove the support bars (If Applicable) and then carefully remove

any top packaging. Remove enough of the packaging to access the

metal cross bars.

NOTICE

PACKAGING AND PALLET MAY BE DIFFERENT THAN

SEEN IN PHOTO

Check Box When This Step is Complete

Remove and open the upper sections

Remove and separate the two crates. Remove the wooden tops (If

Applicable). Be careful when using a hammer to open the crate -

there are sensitive electronic components and glass pieces within

each crate.

NOTICE

PACKAGING AND PALLET MAY BE DIFFERENT THAN

SEEN IN PHOTO

Check Box When This Step is Complete

Jennison Entertainment Technologies Space Ballz Service Manual Page 13